From 1aef22116c0f0d4a6675225ab1b896715f3e9212 Mon Sep 17 00:00:00 2001 From: willemferguson Date: Sat, 10 Nov 2018 13:49:52 +0200 Subject: More accurate CNS calculations (following comments on github) Update table of maximum oxygen exposure durations, used in CNS calulations. This table shows the official NOAA maximum O2 exposure limits (in seconds) for different PO2 values. It also gives slope values for linear interpolation for intermediate PO2 values between the tabulated PO2 values in the 1st column. Top & bottom rows are inserted that are not in the NOAA table: (1) For PO2 > 1.6 the same slope value as between 1.5 & 1.6 is used. This exptrapolation for PO2 > 1.6 likely gives an underestimate above 1.6 but is better than the value for PO2=1.6 (45 min). (2) The NOAA table only tabulates values for PO2 >= 0.6. Since O2-uptake occurs down to PO2=0.5, the same slope is used as for 0.7 > PO2 > 0.6. This gives a conservative estimate for 0.6 > PO2 > 0.5. To preserve the integer structure of the table, all slopes are given as slope*10: divide by 10 to get the valid slope. The columns below are: po2 (mbar), Maximum Single Exposure (seconds), single_slope, Maximum 24 hour Exposure (seconds), 24h_slope */ Then update Calculations of the CNS for a single dive - this only takes the first divecomputer into account. The previous version of the code did a table lookup and used the max O2 exposure for the next-higher PO2 category. This gave a shorter max O2 exposure time and a higher CNS contribution for a specific dive segment, resulting in a slightly conservative value of CNS, often some 2 - 3 % too high. This code does an interpolation for PO2 values inbetween PO2 entries in the lookup table and therefore results in a more accurate maximum O2 exposure time for that PO2. The maximum O2 exposure duration for each segment is also calculated based on the mean depth of the two samples (start & end) that define each segment. The CNS contribution of each segment is found by dividing the time duration of the segment by its maximum exposure duration. The contributions of all segments of the dive are summed to get the total CNS% value. This is a partial implementation of the proposals in Erik Baker's document "Oxygen Toxicity Calculations" */ Overall, this PR does not radically alter the existing CNS calculation, it only makes it more accurate and more consistent by doing interpolation and by using mean segment depth to find PO2. Signed-off-by: willemferguson --- core/divelist.c | 92 ++++++++++++++++++++++++++++++++++++++------------------- core/divelist.h | 2 ++ 2 files changed, 63 insertions(+), 31 deletions(-) (limited to 'core') diff --git a/core/divelist.c b/core/divelist.c index 1054ccc94..a87c1f001 100644 --- a/core/divelist.c +++ b/core/divelist.c @@ -181,54 +181,84 @@ static int calculate_otu(const struct dive *dive) } return lrint(otu); } -/* calculate CNS for a dive - this only takes the first divecomputer into account */ -int const cns_table[][3] = { - /* po2, Maximum Single Exposure, Maximum 24 hour Exposure */ - { 1600, 45 * 60, 150 * 60 }, - { 1500, 120 * 60, 180 * 60 }, - { 1400, 150 * 60, 180 * 60 }, - { 1300, 180 * 60, 210 * 60 }, - { 1200, 210 * 60, 240 * 60 }, - { 1100, 240 * 60, 270 * 60 }, - { 1000, 300 * 60, 300 * 60 }, - { 900, 360 * 60, 360 * 60 }, - { 800, 450 * 60, 450 * 60 }, - { 700, 570 * 60, 570 * 60 }, - { 600, 720 * 60, 720 * 60 } +/* Table of maximum oxygen exposure durations, used in CNS calulations. + This table shows the official NOAA maximum O2 exposure limits (in seconds) for different PO2 values. It also gives + slope values for linear interpolation for intermediate PO2 values between the tabulated PO2 values in the 1st column. + Top & bottom rows are inserted that are not in the NOAA table: (1) For PO2 > 1.6 the same slope value as between + 1.5 & 1.6 is used. This exptrapolation for PO2 > 1.6 likely gives an underestimate above 1.6 but is better than the + value for PO2=1.6 (45 min). (2) The NOAA table only tabulates values for PO2 >= 0.6. Since O2-uptake occurs down to + PO2=0.5, the same slope is used as for 0.7 > PO2 > 0.6. This gives a conservative estimate for 0.6 > PO2 > 0.5. To + preserve the integer structure of the table, all slopes are given as slope*10: divide by 10 to get the valid slope. + The columns below are: + po2 (mbar), Maximum Single Exposure (seconds), single_slope, Maximum 24 hour Exposure (seconds), 24h_slope */ +int const cns_table[][5] = { + { 1600, 45 * 60, 456, 150 * 60, 180 }, + { 1550, 83 * 60, 456, 165 * 60, 180 }, + { 1500, 120 * 60, 444, 180 * 60, 180 }, + { 1450, 135 * 60, 180, 180 * 60, 00 }, + { 1400, 150 * 60, 180, 180 * 60, 00 }, + { 1350, 165 * 60, 180, 195 * 60, 180 }, + { 1300, 180 * 60, 180, 210 * 60, 180 }, + { 1250, 195 * 60, 180, 225 * 60, 180 }, + { 1200, 210 * 60, 180, 240 * 60, 180 }, + { 1100, 240 * 60, 180, 270 * 60, 180 }, + { 1000, 300 * 60, 360, 300 * 60, 180 }, + { 900, 360 * 60, 360, 360 * 60, 360 }, + { 800, 450 * 60, 540, 450 * 60, 540 }, + { 700, 570 * 60, 720, 570 * 60, 720 }, + { 600, 720 * 60, 900, 720 * 60, 900 }, + { 500, 870 * 60, 900, 870 * 60, 900 } }; -/* Calculate the CNS for a single dive */ +/* Calculate the CNS for a single dive - this only takes the first divecomputer into account. + The CNS contributions are summed for dive segments defined by samples. The maximum O2 exposure duration for each + segment is calculated based on the mean depth of the two samples (start & end) that define each segment. The CNS + contribution of each segment is found by dividing the time duration of the segment by its maximum exposure duration. + The contributions of all segments of the dive are summed to get the total CNS% value. This is a partial implementation + of the proposals in Erik Baker's document "Oxygen Toxicity Calculations" using fixed-depth calculations for the mean + po2 for each segment. Empirical testing showed that, for large changes in depth, the cns calculation for the mean po2 + value is extremely close, if not identical to the additive calculations for 0.1 bar increments in po2 from the start + to the end of the segment, assuming a constant rate of change in po2 (i.e. depth) with time. */ static double calculate_cns_dive(const struct dive *dive) { int n; size_t j; const struct divecomputer *dc = &dive->dc; double cns = 0.0; - - /* Caclulate the CNS for each sample in this dive and sum them */ + /* Calculate the CNS for each sample in this dive and sum them */ for (n = 1; n < dc->samples; n++) { int t; - int po2; + int po2i, po2f; + bool trueo2 = false; struct sample *sample = dc->sample + n; struct sample *psample = sample - 1; t = sample->time.seconds - psample->time.seconds; - if (sample->setpoint.mbar) { - po2 = sample->setpoint.mbar; - } else { - int o2 = active_o2(dive, dc, sample->time); - po2 = lrint(o2 * depth_to_atm(sample->depth.mm, dive)); + if (sample->o2sensor[0].mbar) { // if dive computer has o2 sensor(s) (CCR & PSCR) + po2i = psample->o2sensor[0].mbar; + po2f = sample->o2sensor[0].mbar; // then use data from the first o2 sensor + trueo2 = true; + } + if ((dc->divemode == CCR) && (!trueo2)) { + po2i = psample->setpoint.mbar; // if CCR has no o2 sensors then use setpoint + po2f = sample->setpoint.mbar; + trueo2 = true; } - /* CNS don't increse when below 500 matm */ - if (po2 < 500) + if (!trueo2) { + int o2 = active_o2(dive, dc, psample->time); // For OC and rebreather without o2 sensor: + po2i = lrint(o2 * depth_to_atm(psample->depth.mm, dive)); // (initial) po2 at start of segment + po2f = lrint(o2 * depth_to_atm(sample->depth.mm, dive)); // (final) po2 at end of segment + } + po2i = (po2i + po2f) / 2; // po2i now holds the mean po2 of initial and final po2 values of segment. + /* Don't increase CNS when po2 below 500 matm */ + if (po2i <= 500) continue; - /* Find what table-row we should calculate % for */ - for (j = 1; j < sizeof(cns_table) / (sizeof(int) * 3); j++) - if (po2 > cns_table[j][0]) + /* Find the table-row for calculating the maximum exposure at this PO2 */ + for (j = 1; j < sizeof(cns_table) / (sizeof(int) * NO_COLUMNS); j++) + if (po2i > cns_table[j][PO2VAL]) break; - j--; - cns += ((double)t) / ((double)cns_table[j][1]) * 100; + /* Increment CNS with simple linear interpolation: 100 * time / (single-exposure-time + delta-PO2 * single-slope) */ + cns += (double)t / ((double)cns_table[j][SINGLE_EXP] - ((double)po2i - (double)cns_table[j][PO2VAL]) * (double)cns_table[j][SINGLE_SLOPE] / 10.0) * 100; } - return cns; } diff --git a/core/divelist.h b/core/divelist.h index 0f944fe34..94774616e 100644 --- a/core/divelist.h +++ b/core/divelist.h @@ -60,6 +60,8 @@ int get_dive_id_closest_to(timestamp_t when); void clear_dive_file_data(); void clear_table(struct dive_table *table); +typedef enum {PO2VAL, SINGLE_EXP, SINGLE_SLOPE, DAILY_EXP, DAILY_SLOPE, NO_COLUMNS} cns_table_headers; + #ifdef DEBUG_TRIP extern void dump_selection(void); extern void dump_trip_list(void); -- cgit v1.2.3-70-g09d2